Search Results

Search results 1-20 of 1,000. There are more results available, please enhance your search parameters.

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    Quote from Nefertiti: “/---/ now everything is green and working t /---/ ” Have a good one. Quote from geaves: “Well done glad you got it sorted and it's working, my Pi-Hole shows eth0 as well even though it isn't ” And you too. (Let's ignore the insurgent or this thread will get butchered up, as it spins down another rabbit hole.)

  • First - if you want to use the GUI, avoid doing operations on the command line unless it's absolutely required. In some cases CLI changes are erased as of the next, on demand, configuration change. Other possible changes can break OMV's DB or the Debian install itself. If it can be done in the GUI, as a general rule, it's best to do it in the GUI. _______________________________________________________________________ Using Remote Mount, to open the network share on the DNS-323, is usable GUI ap…

  • Connecting is not a problem, but it would be nice if one of these levels solves the network discovery issue. It's worth testing to see. Thanks.

  • I found the EX470 unresponsive this morning,, with no network connectivity. It wouldn't even answer ping! (with standard settings). With a reboot, it was back up again. I have to be objective - the EX wasn't on an UPS and we have minor power hits often enough to make me give it the benefit of a doubt. I any case, I'm happy with my "freebie". It will be interesting to see what it's throughput tests show. A slow sata controller, slow drives and 100mbs. Still, it's got to be better than an R-PI and…

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    My apologies @indragm as well. Here's to hoping you find the problem with tests, swaps, etc.

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    Quote from Nefertiti: “I changed the dhcp pool from 192.168.2.2 to192.168.2.100, But I checked from a browser without add blocking and it is not working wondering If I can setup dns in the router as discourse.pi-hole.net/t/how-do…e-as-their-dns-server/245 with the ip 192.168.2.155 in dns server on the lan page of the router Also http://192.168.2.155/admin is not resolving and when I go to docker container modify just to check under Macvlan settings the IP address is empty other issue but maybe t…

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    Quote from tkaiser: “In case you're not able to understand why recommending fdisk in 2018 is BS nobody can't help you. ” You see,, I didn't say anything even close to that. (Why insist on spinning yarn off into the cosmos?) What I did say, early in the thread and a couple times since, is "use the OEM's tools". (Simply stated, they know their hard drives better than anyone else and their tools are, generally, easy to use.) As a start, "that" is probably the best course for this user to get a defi…

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    I have a post stuck in a queue. As far as tools go, for testing hard drives, the recommendation for using the manufacture's diagnostic tools is the best course for determining drive health. It's their product. _________________________________________________________ Quote from tkaiser: “Tools from last century (like fdisk) often show their age... ” Just like certain physical features we all have, everyone has an opinion, uh? (Just to be sure we're straight on that - this is a forum of opinions …

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    Quote from geaves: “Could you not use smartctl on drive? from the cli that would check the drive. ” I suppose one could try it, it wouldn't hurt anything. However - since OMV doesn't see the partition (or data) I tend to doubt that the drive would respond to OMV's SMART queries. The OEM utilities I mentioned, generally speaking, state one of three things, good, bad, or failing. This is the first thing I'd do and, since we're talking about an external drive with a USB connection, plugging it into…

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    Quote from indragm: “can we go back to why my external hdd suddenly has no partition first? lol ” Have you tested your drive(s) with free manufacture test utilities? Drives fail all the time. If it's dead or dying, nothing can be done about it.

  • I got my old EX470 up and running OMV4! It has a 100mbs NIC, 2GB ram, and performance is not high (passmark 475) but it's an AMD Sempron which is 64bit and it has to be faster that an R-PI. And, it's designed for low power consumption. The hardware is pretty good. I took a page from your book and built OMV on another AMD machine. With a custom made cable to plug a monitor into the mobo, I changed the BIOS setup to boot to USB and changed the disk arrangement to JBOD, in accordance with this thre…

  • (For users who may read this thread) Applies to HP EX470 - EX475 (and potentially others.) I built OMV on another AMD 64bit box, using a USB drive. I used the disk change in BIOS, as noted above (thanks to @creamsicle for that info.), to go strictly to JBOD and set BIOS to boot from USB. I got the onboard NIC to work by using a CN2 to VGA cable (custom made), to connect a monitor, and running omv-firstaid after the first boot. To get a DHCP address, it was necessary to do a hard power reset, as …

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    The address is fine so long as it's in your network and NOT the server's IP address. That appears to be the case. Your server is 192.168.2.150. Pi-hole is 192.168.2.155 so all should work. However, from a previous post, I noticed that your router's DHCP range runs from .2 to .200. You now have two IP addresses, in use, within that range. If possible, I would go into your router and reserve those addresses so your routers DHCP server won't assign them to another host. (Otherwise, it's not the bes…

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    Quote from Nefertiti: “Well it was my question since the ip is now static in the omv network interface and assigned by me outside the dhcp scope in the omv first aid should I also assign it dynamic in the router? getting a little bit confused! ” What's the address you have assigned to OMV, in network settings?

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    Quote from Mr.Grape: “Quote from geaves: “To assign a static IP address to something on your network it needs to be outside of the DHCP scope/range ” Hmmm Imho, no ... Or I misunderstand you. Whether the address is static or dynamic does not depend on whether it is out of the dhcp pool. On the dhcp side, I can give any IP from the pool for a specific MAC address and this IP will be static even though it will be in the dhcp pool. ” In the strictest sense, you're right. One can reserve a DCHP addr…

  • Pi-hole in doker network problem

    flmaxey - - Plugins

    Post

    I can see that the address you were using (.220) was out of your scope .2 to .200. (And now it appears to be back in the DHCP range with an address of .57) What seems to be the issue now? Are changes to network settings working? Or are your changes getting the yellow confirmation banner but not actually being set?

  • *UPDATE DOCKER Pi-HOLE*

    flmaxey - - General

    Post

    My preference is for a Docker, because of shared memory with the host and the minimalist bare-bones approach. However, I appreciate the links. If other packages are bundled in VM's, that work in Virtualbox, they might be useful for exploring and testing other app's without using physical hardware.

  • Questions on Docker

    flmaxey - - Plugins

    Post

    Quote from Methy: “Hello, I have some questions about how docker works ” Dockers are mini-Virtual Machines's not unlike a workstation or server VM running in Virtualbox. Some of the differences are: - A full VM can be, and often is, as fully configured as an OS running on real hardware. A Docker, on the other hand, is designed from the start, to be bare-bones. Dockers have exactly what is needed to run the supported app., complete with all dependencies, and very little more. - A full VM usually …

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    You're right be concerned about 24x7 power consumption. While an old Laptop would be better than an old PC (for power consumption), either of the two will consume far more power than an SBC. An SBC can actually pay for itself in power savings, over time. Take a look at this thread - Energy Efficient Arm Platforms - you might find something you like. When my R-PI or the drive that's attached to it, dies, I'm considering the Rock64 or the newer RockPro64 for good performance and 2 drive attachment…

  • Shared HDD suddenly goes missing

    flmaxey - - General

    Post

    If you're using individual drives in docks: - Try swapping drives into the other drive's dock . - Power on the R-PI with only one drive at a time. - Replace the USB power supply for the R-PI. (A samsung galaxy smart phone supply, at +2 Amps, will stand in for a test.) When you say "external" drive, at you talking about something with it's own enclosure? Most drives with their own shell, along with internal drive models, have free utilities available on their manufacture's website. (WD, Toshiba, …