Search Results

Search results 1-20 of 62.

  • I updated my OMV and rebooted upon reboot I know get the following GRUB Loading. Welcome to GRUB! error: file not found. Entering rescue mode.. Any advice would be greatly appreciated The results below are from an ls command (hd0) (hd0,msdos5) (hd0,msdos1) (hd1) (hd2) (hd3) My setup was OS on a SSD 128gb and I have three 2tb barracuda drives that are raided

  • Hi All, I had some issues earlier that my FS was full, this turned out to be my backup had not mounted the external disk correctly and had filled the roofs. I cleared all this down and rebooted the system All was good so I then updated the system, this is where I have hit issues. I just get a GRUB Loading Welcome to GRUB! error: file not found. Entering rescue mode... grub rescue I have tried re-booting with OMV disk but its just not picking it up. I also tried a redhat disk just to check disk d…

  • GUI Stopped working on OMV

    leester01 - - General

    Post

    I managed to clear it down. The issue was an external drive hadn't mounted and the backup filled the rootfs However I cleared this down by removing the backup files. I have since rebooted an now it has a GRUB error\ error:file not found Entering rescue mode

  • GUI Stopped working on OMV

    leester01 - - General

    Post

    Please note I'm running the following - root@snowdon:/dev/disk/by-uuid# uname -a Linux snowdon 3.16.0-0.bpo.4-amd64 #1 SMP Debian 3.16.36-1+deb8u2~bpo70+1 (2016-10-19) x86_64 GNU/Linux

  • GUI Stopped working on OMV

    leester01 - - General

    Post

    I have just logged on and run a df -h root@snowdon:/dev/disk/by-uuid# df -h Filesystem Size Used Avail Use% Mounted on rootfs 113G 113G 0 100% / udev 10M 0 10M 0% /dev tmpfs 370M 852K 369M 1% /run /dev/disk/by-uuid/7af13745-c1c8-443f-961a-7205b9b79af7 113G 113G 0 100% / tmpfs 5.0M 0 5.0M 0% /run/lock tmpfs 1.7G 4.0K 1.7G 1% /run/shm /dev/md0 5.5T 701G 4.8T 13% /media/9250a5d0-517e-409a-8afd-9071d590f6ec root@snowdon:/dev/disk/by-uuid# However when I go to /dev/disk/by-uuid/ the file it says is 1…

  • GUI Stopped working on OMV

    leester01 - - General

    Post

    Hi All, My OMV GUI has stopped working, I can still access PLEX and SSH onto the server. However It seems very slow. Any advice, suggestions?

  • Thanks - I will look to upgrade

  • ethtool -i eth1 driver: r8169 version: 2.3LK-NAPI firmware-version: N/A bus-info: 0000:04:05.0 supports-statistics: yes supports-test: no supports-eeprom-access: no supports-register-dump: yes supports-priv-flags: no

  • Realtek I belive

  • Debian GNU/Linux, with Linux 3.16.0-0.bpo.4-amd64

  • Yes installed the back ports kernel

  • yes there is a slight improvement - I had to remove min protocol = smb2 as I couldn't connect to the shares via my mac

  • Thanks I changed the following Into the SAMBA extras Options socket options = TCP_NODELAY SO_RCVBUF=65536 SO_SNDBUF=65536 read raw = yes write raw = yes max xmit = 65535 dead time = 15 getwd cache = yes min protocol = smb2 Original DD root@snowdon:/# dd if=/dev/zero of=/media/9250a5d0-517e-409a-8afd-9071d590f6ec/zero.dd bs=1M count=10000 conv=fdatasync 10000+0 records in 10000+0 records out 10485760000 bytes (10 GB) copied, 132.69 s, 79.0 MB/s After changes - AS you can see it root@snowdon:/# dd…

  • re-run again root@snowdon:/# dd if=/dev/zero of=/media/9250a5d0-517e-409a-8afd-9071d590f6ec/zero.dd bs=1M count=10000 conv=fdatasync 10000+0 records in 10000+0 records out 10485760000 bytes (10 GB) copied, 132.69 s, 79.0 MB/s

  • Thanks I changed and run as below root@snowdon:/media# dd if=/dev/zero of=/media/9250a5d0-517e-409a-8afd-9071d590f6ec/zero.dd bs=1M count=10000 conv=fdatasync 0+0 records in 0+0 records out 0 bytes (0 B) copied, 4.4938e-05 s, 0.0 kB/s

  • Please can you elaborate not used dd before

  • Wired speeds Client connecting to 192.168.0.2, TCP port 5001 TCP window size: 129 KByte (default) ------------------------------------------------------------ [ 4] local 192.168.0.48 port 53530 connected with 192.168.0.2 port 5001 [ ID] Interval Transfer Bandwidth [ 4] 0.0-10.0 sec 630 MBytes 528 Mbits/sec Lees-iMac:~ Lee$

  • Please note the above opera speeds are to a wireless mac

  • perf speeds ----------------------------------------------------------- Client connecting to 192.168.0.4, TCP port 5001 TCP window size: 23.5 KByte (default) ------------------------------------------------------------ [ 3] local 192.168.0.2 port 44770 connected with 192.168.0.4 port 5001 [ ID] Interval Transfer Bandwidth [ 3] 0.0-10.0 sec 96.5 MBytes 80.8 Mbits/sec

  • dd if=/dev/zero of=Zootroplolis.mkv 0+0 records in 0+0 records out 0 bytes (0 B) copied, 2.0394e-05 s, 0.0 kB/s