Hello
I have a small homenetwork consisting of a htpc with ubuntu 14.04 and KODI, and a MyCloud 3tb on which I have installed OMV, and my homecomputer. The HTPC and the MyCloud is acting as NFS-servers.
But the transfer speed on the MyCloud is horrible. About 2-3mb/sec. It's not the cable, I have tested several against the htpc and they give me a speed of above 100mb/sec.
I have searched the forum, but I can't seem to find the problem. Just one thing, which might or might not have to do with the issue. I can't set a static IP-address through the GUI. IT always returns an error.
Here is the output of omv-sysinfo (the relevant parts I think):
Code
================================================================================
= OpenMediaVault information
================================================================================
Release: 1.19
Codename: Kralizec
================================================================================
= System information
================================================================================
Linux MyCloud 3.2.40 #2 SMP Wed Mar 25 18:49:40 UTC 2015 wd-2.0-rel armv7l GNU/Linux
================================================================================
= Network interfaces
================================================================================
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000
link/ether 00:90:a9:3c:63:b6 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.4/24 brd 192.168.1.255 scope global eth0
inet6 fe80::290:a9ff:fe3c:63b6/64 scope link
valid_lft forever preferred_lft forever
--------------------------------------------------------------------------------
Interface information eth0:
===========================
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: external
Auto-negotiation: on
Current message level: 0x00000036 (54)
probe link ifdown ifup
Link detected: yes
--------------------------------------------------------------------------------
Driver information eth0:
========================
driver: c2000-geth
version: 1.0
firmware-version: N/A
bus-info: N/A
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: yes
supports-priv-flags: no
================================================================================
= IP packet filter
================================================================================
IPv4:
=====
Chain INPUT (policy ACCEPT)
target prot opt source destination
fail2ban-ssh tcp -- anywhere anywhere multiport dports ssh
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Chain fail2ban-ssh (1 references)
target prot opt source destination
RETURN all -- anywhere anywhere
--------------------------------------------------------------------------------
================================================================================
= IP routing table
================================================================================
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
Alles anzeigen
I would appreciate any help I can get
Cheers