I hope you can help me, I have read here many threads about autoshutdown and WOL but I didn't found the solution.
My NAS doesn't respond to MagicPaket from my PC or WOL from my fritzbox.
I have this issue after I had installed update pakets from OMV 1.19. So I have think I can solve this issue if I update my OMV to 2.1.17.
but it was doesn't so. There no action from my NAS when my PC send an magicpaket
Here My autoshutdown log
Oct 27 12:24:11 :INFO: ' XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX'
Oct 27 12:24:11 :INFO: ' XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX'
Oct 27 12:24:11 :INFO: ' XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX'
Oct 27 12:24:11 :INFO: ' X Version: 0.9.9.10'
Oct 27 12:24:11 :INFO: ' Initialize logging to local6'
Oct 27 12:24:11 :INFO: ' /etc/autoshutdown.conf loaded'
Oct 27 12:24:11 :INFO: ' ------------------------------------------------------'
Oct 27 12:24:11 :INFO: ' Checking config'
Oct 27 12:24:11 :INFO: ' LOADPROCNAMES is set to: 'smbd,nfsd,transmission-daemon,mt-daapd,forked-daapd' (default)'
Oct 27 12:24:11 :INFO: ' TEMPPROCNAMES is set to: in.'tftpd' (default)'
Oct 27 12:24:11 :INFO: ' If you want more processes monitored, please have a look at the expert-settings'
Oct 27 12:24:11 :INFO: ' SHUTDOWNCOMMAND is set to 'pm-suspend''
Oct 27 12:24:11 :INFO: ' Your Kernel supports the following modes from pm-utils:'
Oct 27 12:24:11 :INFO: ' Kernel supports SUSPEND (SUSPEND to RAM)'
Oct 27 12:24:11 :INFO: ' Kernel supports HIBERNATE (SUSPEND to DISK)'
Oct 27 12:24:11 :INFO: ' Kernel supports HYBRID-SUSPEND (to DISK & to RAM)'
Oct 27 12:24:11 :WARN: ' LOADAVERAGECHECK is set to false'
Oct 27 12:24:11 :WARN: ' Ignoring LOADAVERAGE'
Oct 27 12:24:11 :INFO: ' ------------------------------------------------------'
Oct 27 12:24:11 :INFO: ' Reading NICs ,IPs, ...'
Oct 27 12:24:11 :INFO: ' NIC 'bond0' not found, skipping 'bond0''
Oct 27 12:24:11 :INFO: ' NIC 'eth0' found: try to get IP'
Oct 27 12:24:11 :INFO: ' _check_networkconfig(): Run: #1: IP-Adress found'
Oct 27 12:24:11 :INFO: ' 'eth0' has IP: 192.168.178.60'
Oct 27 12:24:11 :INFO: ' NIC 'eth1' not found, skipping 'eth1''
Oct 27 12:24:11 :INFO: ' /tmp/autoshutdown created'
Oct 27 12:24:11 :INFO: '---------------- script started ----------------------'
Oct 27 12:24:11 :INFO: ' 2 test cycles until shutdown is issued.'
Oct 27 12:24:11 :DEBUG: ' _check_ul_dl_rate(): /tmp/autoshutdown/txrx created successfully'
Oct 27 12:24:11 :DEBUG: ' _check_hddio(): /tmp/autoshutdown/hddio created successfully'
Oct 27 12:24:11 :INFO: ' Waiting 5 min until the first check
The NAS response to WOL over Keyboard.
The Backport kernel is upgraded to 3.16
Interface information
Interface information eth0:
===========================
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Link partner advertised pause frame use: Symmetric Receive-only
Link partner advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
--------------------------------------------------------------------------------
Driver information eth0:
========================
driver: r8169
version: 2.3LK-NAPI
firmware-version: rtl8168g-2_0.0.1 02/06/13
bus-info: 0000:02:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: yes
supports-priv-flags: no