SickBeard Basics

    • OMV 2.x
    • Resolved
    • SickBeard Basics

      I wanted to try out Sickbeard so I installed it and tried to load it in the web client (OMV_IP/sickbeard). I must be doing something wrong, but I'm not quite sure what because it isn't coming up no matter what I try. I always get a Gateway Time-out (nginx) in the web browser.

      What I did:
      - Installed Sickbeard
      - Settings:
      - Enable (on)
      - Show tab (off)
      - SSL (off)
      - Proxy Pass (on)
      - Repository (default)
      - Branch (default - master)
      - Second version:Enable (off)
      - Clicked on 'Open Web Client' ->Timeout
      - Tried to open 192.168.1.4/sickbeard -> Timeout
    • Try this:
      - SSL (on)
      - ProxyPass (off)
      but you need to generate an SSL key in your OMV (System / certificates)
      in my case it was the only way that would work Sickbeard

      [IMG:http://i.imgur.com/foEFf8Z.png]
      OMV 3.0.99 (Erasmus)
      HP ProLiant G7 MicroServer N54L AMD Turion II / 4GB
      Kingston SSDNow 200 30GB (OS), 4 x WD red 2TB SATA3 (Data)

      The post was edited 2 times, last by eBomber ().

    • When I set it to your settings it gave an error saying:

      "You have SSL enabled for the main UI, Do NOT enable it here as well."

      I went into 'General Settings' and disabled SSL. That change allowed me to replicate your settings. However I still get the following from the browsers:

      192.168.1.4:8081 => Unable to connect.
      192.168.1.4/sickbeard => Error 404 Sorry, the page you requested was not found.

      I then uninstalled it and reinstalled it and set the settings to exactly what you have listed in your post.

      192.168.1.4:8081 => The page isn't redirecting properly.

      Rebooted to see if that had any effect:

      192.168.1.4:8081 => The page isn't redirecting properly.