I'm building a NAS using OMV, now i have an old sony 8GB drive for OS, but it is big to stay outside of the case, i will buy one nano USB drive, my board has 3.0 and 2.0 USB ports, i'm have a doubt if i should buy a 3.0 drive or 2.0 is OK, the USB drives are:
http://www.ebay.co.uk/itm/SAND…9f986a:g:jpAAAOSwnH1WbnhV
and
http://www.ebay.co.uk/itm/SAND…%3Dpp%26sd%3D371508353130
USB Drive to OS 3.0 or 2.0
-
- gelöst
- jms
-
Get the Ultra Fit. Just make sure to use the backports 3.16 kernel and flashmemory plugin. You will probably have to install in the usb2 port and then move to the usb3 port after installing the 3.16 kernel.
-
The price is so similar, why not get the USB 3.0 drive?
As far as performance goes, it won't make much practical difference in the case where OMV is installed to it, as the system drive doesn't see a lot of I/O.
-
Just install it within OMV itself, from the Systems | OMV-Extras.org page, Kernel Tab.
-
The drive has arrived today i use clonezilla to move my system from a 8 gb drive to this 16 gb, but omv only recognize the same 8gb, who do i expand the fs to use all 16gb, the new drive is usb 3.0 mutch faster on boot and shutdown
-
I recommend gparted live
-
Can you show a screenshot of gparted after cloning with clonezilla?
-
You have two options:
1 - Delete the swap, resize the partition, create a new swap partition, and fix fstab (fastest option)
2 - Move the entire extended partition (with swap partition inside it) to the end of the stick and then resize the first partition.
-
Something is very wrong. You should get that error with method #1. Worst case, it doesn't find swap.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!