today i received my new hardware to build my nas, and a UPS (Conceptronic 650VA / 360W), i installed the nut plugin whit this configuration
Code
driver = usbhid-ups
port = auto, when i go to the system->ups tab i receive an error
Code
Failed to execute command 'upsc 'ups'2>&1':Error: Driver
the ups is connected to usb
so i search on the forum and in one thread i shaw that execute
Code
apt-get install bcsolved the problem, so i executed it and retrieved the output:
Code
Reading package lists... Done
Building dependency tree
Reading state information... Done
bc is already the newest version.
bc set to manually installed.
0 upgraded, 0 newly installed, 0 to remove and 42 not upgraded.
then i reboot the nas, nothing again, so i run
Code
susb
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 001 Device 002: ID 8087:8008 Intel Corp.
Bus 003 Device 002: ID 054c:05b8 Sony Corp.
Bus 003 Device 003: ID 0665:5161 Cypress Semiconductor USB to Serial
Bus 002 Device 002: ID 8087:8000 Intel Corp.
someone could help to configure it
thanks