Problem Setting Up Link Aggregation

    • OMV 2.x

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Problem Setting Up Link Aggregation

      Hi,

      I'm pretty new in using OMV. My NAS has two LAN ports (Supermicro X11SSH-F) and my router is an Asus AC66U (Asuswrt-Merlin firmware) all of which is capable of implementing Link Aggregation. So I decided to take advantage of it.

      For my router, I followed Method 1 of the guide in GitHub. I think I have setup it up properly because when I run the script LinkAgg -s I get "Bond Status: bond0 UP". On the webGUI of my router, I can also see that two of my ports has the same IP address pointing to my OMV.

      I also think that I was able to setup Link Aggregation in OMV properly because I think it was pretty simple. On the options for bonding I chose 802.3ad which is the only only mode also being supported by my router.

      However, checking on the System Logs, I found the following lines:

      Source Code

      1. Jul 16 06:04:56 TheVault kernel: [ 361.801517] bonding: bond0: An illegal loopback occurred on adapter (eth1).
      2. Jul 16 06:04:56 TheVault kernel: [ 361.801522] Check the configuration to verify that all adapters are connected to 802.3ad compliant switch ports
      3. Jul 16 06:04:57 TheVault kernel: [ 363.001436] bonding: bond0: An illegal loopback occurred on adapter (eth0).
      4. Jul 16 06:04:57 TheVault kernel: [ 363.001440] Check the configuration to verify that all adapters are connected to 802.3ad compliant switch ports
      Please, help me figuring out the problem. Thanks.