Can't access webgui for Syncthing

johndoe86x · Dec 31st 2016, 8:09pm

Hello, all, I recently did a clean install of OMV 3.0. Everything seems to be working without issue except that I can't access the syncthing webgui. Everything worked fine with 2.0, so I don't think it's anything I manually changed or pertaining to do with my network. Any help would be greatly appreciated.

[IMG:https://i.imgur.com/319u9dQ.png]

ryecoaaron · Dec 31st 2016, 8:12pm

Did you try making a small change to one of the settings in the web interface so it would re-write the config files?

johndoe86x · Dec 31st 2016, 8:15pm

ryecoaaron wrote:

Did you try making a small change to one of the settings in the web interface so it would re-write the config files?

Thank you for responding. I didn't make any change in the gui or cli, is that something I needed to do?

Sent from my Nexus 6P using Tapatalk

ryecoaaron · Dec 31st 2016, 8:17pm

johndoe86x wrote:

I didn't make any change in the gui or cli, is that something I needed to do?

It is just something I would try. I don't use the syncthing plugin. So, upgrading a working syncthing setup from OMV 2.x to 3.x is not very well tested.

johndoe86x · Dec 31st 2016, 8:26pm

ryecoaaron wrote:

johndoe86x wrote:

I didn't make any change in the gui or cli, is that something I needed to do?

It is just something I would try. I don't use the syncthing plugin. So, upgrading a working syncthing setup from OMV 2.x to 3.x is not very well tested.

I apologize for my ignorance, but I'm not exactly sure what I need to change. Everything was a fresh install, so no remnants should remain from 2.0

Sent from my Nexus 6P using Tapatalk

ryecoaaron · Dec 31st 2016, 8:31pm

I missed the clean install comment. I will have to try installing it to see if something is broken.

ryecoaaron · Dec 31st 2016, 8:38pm

I just installed the plugin on a fresh VM and it seems to be working for me. Did you change the gui address to 0.0.0.0?

johndoe86x · Dec 31st 2016, 8:48pm

ryecoaaron wrote:

I just installed the plugin on a fresh VM and it seems to be working for me. Did you change the gui address to 0.0.0.0?

No, I left the GUI address at 127.0.0.1 and the Listen Address at 0.0.0.0.

Edit: Ah, right after I typed this up I saw the instructions below the GUI address line. Use 0.0.0.0 for all hose IPs.. It seems to be working after changing that. Thank you!

Can't access webgui for Syncthing

Can't access webgui for Syncthing

RE:

ryecoaaron wrote:

johndoe86x wrote:

RE:

ryecoaaron wrote:

johndoe86x wrote:

ryecoaaron wrote:

Tags

Similar Threads