Shutdown of system during copying documents to NTFS HDD via USB

  • Dear All,


    basically I made now my first experiences with OMV and also with Linux :) due I want to exchange my whole Wind*** infrastructure to Linux based systems.


    My first project is to set up a NAS system with Banana Pro and OMV with following SW configuration:
    OMV Version 2.2.13
    Prozessor ARMv7, rev4
    Kernel: 3.4.108+
    I still know that NTFS formatted HDD are not recommanded for using at Linux environments, but at the moment I have some free space issues due I can not park all data at the moment on a separat disk.


    Anyhow I connected and mounted my 250GB Hitachi HDD via USB to the Banana and released access to it also via FTP.
    Then I wanted to copy data from my Synology NAS direct to the HDD at the Banana. Therefore I established a direct remote connection from the synology to the Banana via FTP. Then I started to copy some media files.
    After one or two minutes the Banana turned off without any notification.
    I tried the mentioned procedure several times with same results.


    Due that I decided to connect the HDD via SATA to the Banana and tried to copy the files again with the Synology NAS. With success :)


    Then I tried again to connect the HDD to USB and the Banana shut down without any notification.


    My question is now how I can check if there is any log available which references to this behavior?
    I would appreciate if somebody can give me a hint or introduction how I can figure out this?


    Kindly Regards,
    chivas

  • Thank you for your feedback. I will try again the set-up with USB connection again, but using the second power supply I have.


    The current setup was:
    o) test case with USB connection:
    - Power supply Banana with 5V/2.4A
    - HDD connected via USB/SATA adapter and own power supply for HDD
    0) test case with eSATA connection:
    - Power supply Banana with 5V/2.0A (other type as for test case 1)
    - HDD connected via power supply connector from Banana for 2.5" HDD

  • Hello,
    I made several tests with different kind of USB power supplies and I can confirm that the described issue above was related to a weakness issue of the first power supply I used.


    Therefore I can not recommend following power supply:
    - https://www.amazon.de/KabelDir…teerkennung/dp/B013I9TMZ8


    I can recommend following devices, where my configuration worked well:
    - https://www.amazon.de/Ladeger%…438&sr=1-3&keywords=aukey
    - https://www.amazon.de/Vilros-R…words=vilros+power+supply


    Thanks for your input Wolf2000.
    Regards,
    chivas

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!