Install 3.0.36 i386, network missing

audi30tdi · 15. Juni 2017

Hello!

I just installed 3.0.36 i386 Version, that was the newest Version for i386 I found. Everything goes ok during installation, restart computer and login on console. But it don't show any ipadress, so I run omv-firstaid, and configure the network manually.

And after answer NO to enabled WOL, I got an error:address6: the value ' ' is not a string.

And the ip I set was not saved, as I can't Connect to that ip. How can I resolve this??

Regards
Kåre!

gderf · 15. Juni 2017

That bug was solved in more recent versions of OMV 3, but there are none for i386.

Are you sure you cannot use the 64bit version?

audi30tdi · 15. Juni 2017

Yes, have tried a 64-bits Version and won't install. have to old computer for that Version..........

Isn't it any solution, or workaround for this error??

ryecoaaron · 15. Juni 2017

Just because it doesn't show an address doesn't mean it doesn't have one. What is the output of: ip addr right after installing and logging in? If you truly don't have an ip, install Debian first. There is a thread showing how to install OMV on Debian.

audi30tdi · 15. Juni 2017

The output of ip addr is;

1: lo <LOOPBACK, UP, LOWER_UP> mtu 65536.................

2: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN Group default qlen 1000
link/ether 00:08:a1:c5:d6:a6 brd ff:ff:ff:ff:ff:ff

ryecoaaron · 16. Juni 2017

DId you check the cable? The system is finding the network adapter. You could also do:

dhclient -r
dhclient eth0

Jetzt mitmachen!