Unable to installe autoshutdown plugin - maybe my Network is broken ?
-
- OMV 3.x
- romibaer
-
-
In the network section, please add a dns server to your network interface configuration.
-
-
-
Depends if the router forwards the dns queries. Is that really the gateway ip?
Change the dns to 8.8.8.8 and report back. -
-
Switch then to dhcp. Then access the server via ssh run some commands there that you can post the output here.
ip addr show dev eth0
ip r s
cat /etc/resolv.confThe error is that your nic doesn't supprt blinking led identification. Nothing to worry about.
-
-
ok - her`s my screen
i think i have problems with the nameserver - this was my old ip adresse 192.168.178.1
it is now 192.168.178.100do i have to change this ?
-
New Cable Modem --> new MAC address.
Is your provider aware of this ?
Is your internet connectivity working with any other device ? -
Yes - my internet connectivity is working with any other devices as intended.
This is the only problem i have actually
-
-
What is the address for your FritzBox ?
This should be the one you set as DNS-server on OMVTypically (if you did not change it yet) this sould be 192.168.178.1.
Try that address. -
The Adress is 192.168.178.100
this is also what i already set as dns...i think the problem could be:
cat /etc/resolv.conf
gives the following output:
search fritz.box
nameserver 192.168.178.1This is my old ip - the new one should be 192.168.178.100 - or am i wrong ?
don`t know how to change this...
-
ok - figuerd out how to fix my problem...
i manualy changed etc/resolv.conf via nano etc/resolv.conf so the nameserver-adress was 192.168.178.100
This fixed my Problem and i was able to install the Plugin...
still not able to identify my networkd card as mentioned above
don`t know what the problem is
-
-
still not able to identify my networkd card as mentioned above
don`t know what the problem is
Already told you, your card doesn't have support for blinking leds, at least that's the error. What the command does is blink the leds on the ethernet port to id them. That's in case you have more than one port and you don't know which ethX is the physical port.
-
Ah ---ok thanks for the Information...i didn`t understand that...
So ok - i`m happe and my NAS is working like intended
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!