Network manager with OMV on Banana Pi

    • OMV 3.x
    • Network manager with OMV on Banana Pi

      Hi All,

      I have a Banana Pi M2U - i know this is not a good board and it is not supported by Armbian so I am limited to the images I can use (very limited).

      Anyway, I have Raspian / jessie (kernel 3.10.107 - i know this is old but it is most current available) installed with OMV installed on it. I have got it working quite well and it is stable.

      In the OMV GUI there are no network interfaces showing. If I try to add a network interface using the OMV GUI, it works but causes a conflict with the existing network interface that is installed/configured as part of the standard image.

      What I want to do is get control of the network interfaces and remove the preinstalled config then add new through the OMV GUI.

      Can someone help with what I need to do? I think it would help if I install a network manager so I can clean up what is currently installed.

      Many thanks for any assistance.
    • Hi you have in the network interface:

      and

      Source Code

      1. nano /etc/dhcpcd.conf
      And at the end:
      You have to adjust it to your Network

      interface eth0

      static ip_address=192.168.1.40/24
      static routers=192.168.1.1
      static domain_name_servers=192.168.1.1

      interface wlan0
      static ip_address=192.168.1.50/24
      static routers=192.168.1.1
      static domain_name_servers=192.168.1.1
      forum-bpi.de Visit on and help us, The Germany Forum :thumbsup:
      github.com/Wolf2000Pi
      Banana Pi /Armbian 3.4.109 / Openmediavault 2.x
      Banana Pi /Armbian 4.11.5-sunxi / Openmediavault 3.0.xx (Test)
      Dell Inspiron One 2205 | Openmediavault 3.0.xx / Kernel 4.7 (Test)
    • Users Online 1

      1 Guest

    • Tags