Hi, I just installed a fresh system with 3.0.94 on a USB drive. The system also has a 500GB hard drive.
I tried to set the file quota using the WebGUI, input the size limit and click save... However, the "Applying configuration" windows doesn't come up as usual and it doesn't show the small red triangle as well.
When I go back in the settings again, nothing is recorded.
Has anyone experienced this? Any suggestion will be welcome.
Regards,
Below is the /etc/fstab listing
# <file system> <mount point> <type> <options> <dump> <pass>
# / was on /dev/sdc1 during installation
UUID=60d6f81f-9f37-444d-9bfa-f8069bb8e83b / ext4 noatime,nodiratime,errors=remount-ro 0 1
# swap was on /dev/sdc5 during installation
#UUID=8617f45b-8bc5-45d3-8df8-c32959ca7bca none swap sw 0 0
tmpfs /tmp tmpfs defaults 0 0
# >>> [openmediavault]
/dev/disk/by-label/MB500 /srv/dev-disk-by-label-MB500 ext4 defaults,nofail,user_xattr,noexec,usrjquota=aquota.user,grpjquota=aquota.group,jqfmt$
# <<< [openmediavault]