Flash-Speicher und Swap-Partition

  • Hallo alle,


    ich habe ein OMV NAS problemlos auf einer 8 GB SD-Karte aufgesetzt. Bei der Installation des Systems wird eine 3,5 GB große Systempartition und eine 4 GB große Swap-Partition eingerichtet. Danach habe ich das Flashspeicher Plugin installiert und wie dort in den "Notes (optional)" angegeben die Verwendung der Swap Partition auskommentiert.


    Wird nun diese Swap-Partition nach wie vor vom System benötigt oder kann man unter Verwendung eines Partitionierungstools diese Partition entfernen und danach die Systempartition entsprechend vergrößern?


    Vielen Dank für die Hinweise und freundliche Grüße.


    Hello everyone,


    I have an OMV NAS easily mounted on an 8 GB SD card. When installing the system, a 3.5 GB system partition and a 4 GB swap partition will be set up. Then I installed the flash memory plugin and commented out how to use the swap partition in the "Notes (optional)".


    Is this swap partition still needed by the system, or can you remove that partition using a partitioning tool and then increase the system partition accordingly?


    Thanks for the hints and best regards.

    2 BananaPi, 1 OrangePiPC+, 1 OrangePiPC with OMV 6.0.x

  • Die restliche Partition kann verwendet werden. Kannst du also auch als Datenpartition o.ä verwenden. Empfehlen würde ich dir das allerdings nicht. Das verkürzt die Lebenszeit einer SD Karte noch zusätzlich.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!