Configure using command line?

  • Hi,


    When I upgraded from omv 2 -> 3 I saved the config.xml on omv 2. After installing omv 3 I clicked around in the webGUI to get the same configuration as in the backed up config.xml file.


    Is there a way to configure omv using command line instead of webGUI? It would simplify upgrade a lot. Best would be if configuration could be extracted from omv 3, migrated to omv 4 and then applied.


    /Simmarn

    • Offizieller Beitrag

    If you knew all of the exact configs, you could use rpc calls but I bet it would be faster to use the web interface.

    omv 7.0.4-2 sandworm | 64 bit | 6.5 proxmox kernel

    plugins :: omvextrasorg 7.0 | kvm 7.0.10 | compose 7.1.2 | k8s 7.0-6 | cputemp 7.0 | mergerfs 7.0.3


    omv-extras.org plugins source code and issue tracker - github


    Please try ctrl-shift-R and read this before posting a question.

    Please put your OMV system details in your signature.
    Please don't PM for support... Too many PMs!

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!