NUT fot Eaton 9PX (network connection)
-
- OMV 4.x
- gelöst
- Constantine
-
-
Hi @Constantine
maybe you have the right driver already. When you try to save the NUT configuration, the driver tries to communicate with the UPS immediately. If no communication is possible, you´ll get this error message.
So for a first attempt ensure that the UPS is reachable via network and try to save the configuration again.
I had a similar problem / behavior in the past.
If you want to look for the right driver here is the NUTcompatibility list
-
So for a first attempt ensure that the UPS is reachable via network and try to save the configuration again.
what do you mean?
-
The screenshot shows an error which happened while you were trying to save the plugin configuration, I assume. Right? Therefore you should ensure that the UPS is switched on and can be reached over the network ("ping"). Then you should make a new attempt to save the plugin configuration.
-
Therefore you should ensure that the UPS is switched on and can be reached over the network ("ping").
-
-
desc = "Eaton 5PX 1500"
-
This is an unrelated python issue: https://github.com/python/cpyt…5d1c1f8c2989578a8fc2c1de6
/usr/lib/python3.5/weakref.py
Changing the two lines below fixed the error for me....
Code- def remove(wr, selfref=ref(self)): + def remove(wr, selfref=ref(self), _atomic_removal=_remove_dead_weakref): - _remove_dead_weakref(d, wr.key) + _atomic_removal(d, wr.key)
-Mike -
Changing the two lines
-
Some more explanations would be helpful. It is not our task to try to find out what you have done in detail.
-
Some more explanations would be helpful. It is not our task to try to find out what you have done in detail.
-
I apologize for my explanations
OMV - new system for mep.s. i'm from russia, english is bad
-
As @mikebetz42 wrote you have to install the nut-snmp package. Therefore edit the mentioned python file and try to install the package again. The package must be installed first without any error messages reported. If this is done then you should be able configure the omv ups plugin.
-
Ok, when you want to edit the file then you have to remove the line which is marked with "-" and add the line which is marked with "+" instead of it but without the "+" sign itself.
-
-
Maybe you find the solution here: Nut plugin no graph
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!