So I installed Zoneminder using docker following "Techno dad's" advice on youtube. Since then I can't get the internet access of OMV to work. apt-get update does not work anymore, though I did not change anything else
Any ideas?
My network conf:
Code
# The loopback network interface
auto lo
iface lo inet loopback
# eno1 network interface
auto eno1
allow-hotplug eno1
iface eno1 inet static
address 192.168.2.101
gateway 192.168.2.1
netmask 255.255.255.0
pre-down ethtool -s $IFACE wol g
iface eno1 inet6 manual
pre-down ip -6 addr flush dev $IFACE
Alles anzeigen
ifconfig says:
Code
docker0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 172.17.0.1 netmask 255.255.0.0 broadcast 172.17.255.255
ether 02:42:c8:96:f3:69 txqueuelen 0 (Ethernet)
RX packets 38111 bytes 2098657 (2.0 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 284664 bytes 545938584 (520.6 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
eno1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.2.101 netmask 255.255.255.0 broadcast 192.168.2.255
ether ac:1f:6b:85:59:62 txqueuelen 1000 (Ethernet)
RX packets 378459 bytes 553213134 (527.5 MiB)
RX errors 0 dropped 1438 overruns 0 frame 0
TX packets 53273 bytes 23470147 (22.3 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device memory 0xdf200000-df27ffff
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Lokale Schleife)
RX packets 1734 bytes 141325 (138.0 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 1734 bytes 141325 (138.0 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
vethe0d43dc: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
ether 3a:ba:c0:6c:e1:c6 txqueuelen 0 (Ethernet)
RX packets 38111 bytes 2632211 (2.5 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 284664 bytes 545938584 (520.6 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Alles anzeigen
And finally route: