Hi,
I updated my System from OMV 3 to OMV 4 had no problems with it. I have 3 different hard disks. On the first hard disk is OMV installed and the other two are full of data. Unfortunately, after upgrade I only can acces one of the two data disks. In the webgui I see all three harddisks but only two hard disks are found in the data systems. I tested some commands and will display the results. I would be very happy if anyone can helpme since I'm missing a lot of data from this disk.
blkid:
/dev/sr0: UUID="2010-10-18-15-41-46-00" LABEL="PCGH" TYPE="iso9660"
/dev/sdb1: LABEL="HDD2" UUID="1e0515b4-f4fc-4613-9504-63ad792da5c5" TYPE="ext4"
/dev/sda1: UUID="be8f0e01-47f3-449e-b8c6-8e4c417ca490" TYPE="ext4" PARTUUID="15e
/dev/sda5: UUID="4fcd4503-7f46-4a12-8c66-36594eba4a68" TYPE="swap" PARTUUID="15e
parted -l:
Model: ATA SAMSUNG HD501LJ (scsi)
Disk /dev/sda: 500GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Disk Flags:
Number Start End Size Type File system Flags
1 1049kB 498GB 498GB primary ext4 boot
2 498GB 500GB 2010MB extended
5 498GB 500GB 2010MB logical linux-swap(v1)
Model: ATA WDC WD30EFRX-68E (scsi)
Disk /dev/sdb: 3001GB
Sector size (logical/physical): 512B/4096B
Partition Table: gpt
Disk Flags:
Number Start End Size File system Name Flags
1 1049kB 3001GB 3001GB ext4
Model: ATA WDC WD30EFRX-68E (scsi)
Disk /dev/sdc: 3001GB
Sector size (logical/physical): 512B/4096B
Partition Table: gpt
Disk Flags:
Number Start End Size File system Name Flags
1 1049kB 3001GB 3001GB ext4