Hallo,
ich stehe vor einem Problem.
Habe mein RAID5 erweitert (auf 6x10TB) und kann das Dateisystem nicht vergrößern über die GUI.
Hatte mich damals für das btrfs-System entschieden.
Alle Freigaben wurden bereits entfernt.
Kann mir da jemand helfen?
Hallo,
ich stehe vor einem Problem.
Habe mein RAID5 erweitert (auf 6x10TB) und kann das Dateisystem nicht vergrößern über die GUI.
Hatte mich damals für das btrfs-System entschieden.
Alle Freigaben wurden bereits entfernt.
Kann mir da jemand helfen?
Du kennst die Nachteile von Raid5?
Was willst du damit erreichen?
Helfen kann dir mit den Informationen niemand.
RAID5 ist für mich die Wahl gewesen.
Der Speicher soll vergrößert werden.
Welche zusätzlichen Informationen wären denn nötig?
Zitatbtrfs filesystem resize 1:max /dev/md127
ERROR: resize works on mounted filesystems and accepts only
directories as argument. Passing file containing a btrfs image
would resize the underlying filesystem instead of the image.
Hatte mich damals für das btrfs-System entschieden
mdraid5 combined with btrfs is bad since you suffer from the classical parity RAID 'write hole' in case your array degrades and then a simple crash or power loss can result in your whole btrfs filesystem being in a state where it's not able to repair it (as in: total data loss).
With raid5+btrfs you would need to recreate the mdraid this time using an additional SSD as log device (can't be done from the OMV UI) to be not affected by the 'write hole' problem any more but RAID5 with today's large disks is asking for troubles anyway... a RAID rebuild can take days or even weeks and in this time any more disk failure results in your whole array being gone anyway...
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!