How to manually setup the dns?
I tried via the webgui but it broke my network twice, tried manually to edit the /etc/network/interfaces but this is what I get (see attachment)
kalizec 1.0.8 here
thanks
How to manually setup the dns?
I tried via the webgui but it broke my network twice, tried manually to edit the /etc/network/interfaces but this is what I get (see attachment)
kalizec 1.0.8 here
thanks
This happens when you set it via CLI?
What happens when you set it via GUI?
Greetings
David
Via GUI once i press "apply" the progress bar shows up and never stops, then i get "communication failure" error and i can't even ping the server, it totally broke my network and it doesn't connect anymore (I also checked the arp table in case it got a different ip).
I had to reinstall it twice now i'm on a fresh install i don't want to break it once again.
When i try via ssh i get what you see in the attachment, it's kinda weird.
What do you mean by CLI?
cli = command line
Do not do things in command line that are in the webgui.
In the webgui try to set your:
primary: 192.168.0.1 (or whatever your router's address is)
secondary: 8.8.8.8
cli = command line
Do not do things in command line that are in the webgui.
In the webgui try to set your:
primary: 192.168.0.1 (or whatever your router's address is)
secondary: 8.8.8.8
I don't know the command to set it by CLI, but as said earlier i tried twice without success via GUI and it disconnected.
Is there a file where the primary is stored?
Try in cli use this command:
omv-firstaid
Then choose the network interface option.
Thanks it worked, after reconfiguring the network via CLI i managed to cahnge succesfully the DNS via WEBGUI
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!