I am trying to install OMV 1.9 on a new HP ML310e gen8 ver 2 server with a smart array p222 card in it. I have 1 logical drive setup up in the array on 1 500GB and then plan on adding 3 3TB disks in raid 5 after the install. The embedded array controller is disabled.
During the install, it gets to the screen where it is scanning the hard disks and just sits at 52%. I am installing from a usb stick and have tried re-downloading the iso and creating the bootable usb stick thinking it may have been a corrupt download or file, but still gets stuck at the same spot.
I have tried removing and disabling everything and hooked up a sata drive in place of the dvd drive thinking it is a controller issue. It still won't get past the same spot in installation. There is always the same error saying there are multiple drives and to make sure I pick the right one, but it doesn't get past the scanning disks.
I have disable the serial port, set on board sata controller to legacy. Ideally I would like to use the P222 for the hardware raid.
Are there any other ideas to try?
Andrew