Search Results

Search results 1-20 of 61.

  • SSD or USB Key?

    exyu74 - - My NAS Build

    Post

    It would be nice if any users tell about write mount and time in use of their ssd without trim(usb or sata - no matter). I`m just curious. My would be 520gb writen after 2 to 3 years(3 time fresh install). Smart: SanDisk SDSSDA120G 9 Power_On_Hours_and_Msec -O--CK 000 100 000 - 10864h+00m+00.000s 230 Life_Curve_Status -O--CK 100 100 000 - 408022220895 (how should i read this? ) . 241 Lifetime_Writes_GiB ----CK 253 253 000 - 520

  • slow SSD vs HDD

    exyu74 - - Motherboards

    Post

    Is it possible to apply steps as 1G-100G offset to ssd`s who where used as data storage or is only for OMV Os ?

  • Quote from MPPurcell: “ I suppose my next step is to reinstall OMV, and see what happens with that. I'll wipe the one disk first, 1.and see if the OS will pick up the other disks as they were. 2.I have another issue to consider, which I may post separately. When I did the current installation, I could not get OMV 4.x to work with my equipment--hence I've been using 3.x. I wonder if there is any reason I could get 4.x to work now. ” Well feloow MPPurcel, to get into bloodstrem of OMV, u need to l…

  • MONITOR Hard Disk Drive Speed

    exyu74 - - General

    Post

    TNX 4 ULTRA-Fast responce !!!

  • MONITOR Hard Disk Drive Speed

    exyu74 - - General

    Post

    Tnx it does a job. Only, how do i make to stop,esc button does not help?

  • MONITOR Hard Disk Drive Speed

    exyu74 - - General

    Post

    As a subject say, is there a way to see a read-write speed (when copying) ?

  • How to EJECT hard drives from OMV ?

    exyu74 - - General

    Post

    Actually the question should be, what are proper steps to do? I'm asking because in the past i have done several times in bad way before and therefor left many dead hyperlinks and on the end system disk failure of OMV(reinstall). There are two hard drives and next are places where they are : -Storage: 1. Union Filesystems (Merged in one whole by) 2. File systems(two hard drives separately and as one whole) 3. S.m.a.r.t. --> Scheduled tests -Access Rights Management 4.User? There is another(3th) …

  • My Home Server/NAS

    exyu74 - - My NAS Build

    Post

    Quote from geaves: “Quote from exyu74: “Dont forget Gen8 supports disks till 4tb. ” No....look here ” JEEZ , why i have not seen that before ?!!! Thanx, at least one enigma is resolved if was enigma at all ! Many thanx !!!

  • My Home Server/NAS

    exyu74 - - My NAS Build

    Post

    Yes, it is a user Spy Alelo. But a post about it i can not recon. As far as i remember there was first support till 3Tb,later HP made it by firmware support till 4Tb. Everyone who use "Gen8" 4Tb drives or less".As i said even in "white pages" stud support till 4Tb. I do have i 8tb drive in Synology nas.If i put in Omv,if is not suported what kind of message should i resive? Perhaps is best to contact Spy Alelo about this object?

  • From the beginning is Omv Nas made as media vault ONLY for streaming. Smart->Settings->Power mode. 1.Which option is best for my use,so the hdd`s do not spin 24/7 ??? (the disk`s are:2X WD Red4tb, WD Green 1tb ,Ssd-Omv os on it) There are Scheduled tests for all device`s on every monday at night. 2. System Logs->Logs->Syslog I notised a message: monit[767]: `fs_srv_dev-disk-by-label-media4tb` space usage 99.9% matches resource limit [space usage>85.0%] The "media4tb" is filled with data and ther…

  • My Home Server/NAS

    exyu74 - - My NAS Build

    Post

    Quote from Xanderlicious: “Quote from exyu74: “I do have one question i found very important! We use the same HP and hardware setup. Do u use also a sd/usb stick(internal) boot with grub? Or without and still able to boot up normaly? ” I have managed to boot directly from the Ssd connected to the ODD port. Configured as Raid 0 Sent from my ONEPLUS A6003 using Tapatalk ” Hmmm,strange...when i was installing the first time few years ago,even with raid0 ssd i needed to put a grub on usb. This time …

  • My Home Server/NAS

    exyu74 - - My NAS Build

    Post

    Well,that`s what they say-there is a guy on this forum who works at HP. As in white sheets info. Of course,this info is only about HP Gen8 Proliant microserver. Gen10 can recive bigger hdd`s than 4tb.

  • My Home Server/NAS

    exyu74 - - My NAS Build

    Post

    I`m using Gen8, but i`m not so tech savy as u are. Dont forget Gen8 supports disks till 4tb. Quote: "Can anyone recommend a good Mobo+CPU combo that supports ECC ram and is fairly cheap?" ...u should go i this direction: ASRock H170M-ITX/ac (or similar with 6 sata ports) But in the and with all goodies u and up with 600€ So,better stay for time beaing with HP. I do have one question i found very important! We use the same HP and hardware setup. Do u use also a sd/usb stick(internal) boot with gr…

  • HPE Proliant Servers

    exyu74 - - My NAS Build

    Post

    Hello me again... Can someone tell me or explain to me some unortodox mystery that hunts from this morning. I have HP proliant Gen8 microserver. One or two years ago i installed Omv on HP with ODD/5th sta port and Grub on intern usb port. Because of some amateur handeling i needed to reinstall. That went without a problem two day`s ago. Till then i was preoccupied with copying grub on usb. This morning i discovered that Omv on ODD and 3 hdd`s(1,2,4port) is BOOTING UP without problem ?!?! Same OM…

  • Quote from sno0k: “It happens, because of the existing path addition in the policy. A created folder is initially saved on only one drive of your data pool (randomly on one of the drives with the most free space). Therefor your files will be only copied to the drive where the folder is located. You have to choose the most free space policy, if you want a performance as you described. ” Thank u snoOk that is exactly what i needed! My set up: 2 hdd`s. First is full(of media/movies)(4tb-left 2gb of…

  • Add 3th NFS Share

    exyu74 - - NFS

    Post

    I`m trying to add a 3th Share to same hard disk,but it wont go. Here is warning massage: Failed to execute command 'export PATH=/bin:/sbin:/usr/bin:/usr/sbin:/usr/local/bin:/usr/local/sbin; export LANG=C; rm --recursive --force '/export/NetBackup2syn' 2>&1' with exit code '1': rm: cannot remove '/export/NetBackup2syn': Device or resource busy Error #0: exception 'OMV\ExecException' with message 'Failed to execute command 'export PATH=/bin:/sbin:/usr/bin:/usr/sbin:/usr/local/bin:/usr/local/sbin; …

  • HPE Proliant Servers

    exyu74 - - My NAS Build

    Post

    Quote from mika91: “Hi, Just received my Gen8. I planned to install OMV on SSD, and use ODD sata, but after some research this morning, it seems impossible to properly boot from port5. My data disks will not be in a RAID (I'm using snapraid), and forcing SSD boot with raid 0 trick is not reliable for me, if a reboot / cold boot is not possible. So what are the possible solutions ? - install omv on USB (+SSD for data)? - install omv on sd card (+SSD for data)? - use USB only for boot partition, a…

  • OMV Setup Videos

    exyu74 - - General

    Post

    OpenMediaVault - S.M.A.R.T. management Next video is not made by me, just stumbled on youtube. youtu.be/nA6BBhPO5AA

  • Quote from erik: “Same here, HP Gen 8 OMV (2.2.14) and Synology DS112+ with Seagate 8 TB Archiv, working for nearly 2 years: 1.) rsync works, fine, better option for me 2.) setup a backup share on the Synology with user and password. 3.) Connect this share to OMV HP Gen8 with "Remote Shares" - but map this Remote Share to a local folder which is NOT on your basic OMV file system. Otherwise every error of the Remote Share connection (i.e. Synology offline) causes possible overrun of this file sys…

  • Syncthing

    exyu74 - - Plugins

    Post

    Should i follow these steps to resolve my problem? How to make a good Media share for Emby and PlexMediaServer