lost networking after cloning OMV to new entirely new hardware

    • OMV 0.4
    • lost networking after cloning OMV to new entirely new hardware

      Hello!

      Been trying to clone a working OMV system to much newer hardware using clonezilla. Was able to boot the new system but I lost my networking and cannot ssh, or see my smb shares on the network. I also tried running omv-firstaid but it just go to a white screen and command line.

      the error i've been getting while watching the console is:

      configuring network interface ...siocsifaddr: no such device
      etho: error while getting interface flags: no such device
      siocsifnetmask: no such device
      eth0: ERROR while getting interface flags: no such device
      failed to bring up eth0


      I'm currently on version 0.4.38 (fedaykin)
      old hardware is pentium 4 3.20 ghz
      new hardware is xeon e3-1225 (dell powered t20)

      i ran ifconfig of old OMV hardware and got:

      eth0 Link encap:Ethernet HWaddr 00:13:20:e9:76:11
      inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
      UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
      RX packets:96124 errors:0 dropped:0 overruns:0 frame:0
      TX packets:418912 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:1000
      RX bytes:11838187 (11.2 MiB) TX bytes:612008232 (583.6 MiB)

      lo Link encap:Local Loopback
      inet addr:127.0.0.1 Mask:255.0.0.0
      UP LOOPBACK RUNNING MTU:16436 Metric:1
      RX packets:2314 errors:0 dropped:0 overruns:0 frame:0
      TX packets:2314 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:0
      RX bytes:488991 (477.5 KiB) TX bytes:488991 (477.5 KiB)

      tun0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
      inet addr:10.8.0.1 P-t-P:10.8.0.2 Mask:255.255.255.255
      UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
      RX packets:0 errors:0 dropped:0 overruns:0 frame:0
      TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:100
      RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)


      when i ran ifconfig on new hardware i did not get any messages regarding eth0 or tun0. i only got messages with: lo

      i also tried: rm /etc/udev/rules.d/70-persistent-net.rules but still getting the same problem

      I know its not a defective hardware because I can get on the web with new machine using a Linux MINT liveCD

      please help! obviously I am not very good with linux and I hope i provided enough information.