Hi,
yesterday I have installed OMV 3.0 beta on my ASROCK Q1900 Pro 3.
The board is equipped with an integrated celeron, 8GB ram, and gibabit lan using Realteck RTL 8111.
Controller was an IMB m1015 in with original firware in IR mode.
Everything has gone fine.
I have then flashed to LSI 9211-8i IT mode and reinstalled OMV 3.0... SURPRISE. I have been asked for the Network card as the setup was not able to recognize it. No card in the list worked !
I have then tried to install OMW 2.1 and it passed the network card recognition and network configuration without problems.
It seems OMW 3.0 has added some incompatibility.
Have you some suggestion ?
Regards,
Giuseppe Chillemi