Hi,
system is being reshaped after 2 drives have been added.
I see no percentage on the gui, nor actuall speed ad projected completition time.
It would be good to have this information.
However, how could I obtain it from the command line ?
Hi,
system is being reshaped after 2 drives have been added.
I see no percentage on the gui, nor actuall speed ad projected completition time.
It would be good to have this information.
However, how could I obtain it from the command line ?
cat /proc/mdstat
Hallo,
how much time does a reshaping need?
I have expand my RAID5 (4 x 1TB) with 1 drive same size, but the "progress bar" does not continues.
However, the light indicator flickers very heavy and the cpu load is also high, it seems he´s doing something ;-))
Actually there 3,9% completed, time left: 612min.... a joke?
how much time does a reshaping need?
Depends on lots of factors... drive speed, drive size, system speed, etc.
Actually there 3,9% completed, time left: 612min.... a joke?
Nope. That is only 10 hours. It might speed up at the end.
Ok, reshaping process has been finished.
As an improvement: the complete task (what´s going on, what I have to do....) should be explained before starting.
- reshaping has taken more than 11 hours
- resizing has to do next (how should I know that)
A plus is that the resizing process will be updated automatically, so I can follow time and status....
I tried adding a drive and it is now listed as a spare and I can't grow the RAID.
md127 : active raid5 sdn[4](S) sde[0] sdh[3] sdg[2] sdf[1]
11720661504 blocks super 1.2 level 5, 512k chunk, algorithm 2 [4/4] [UUUU]
How do I tell it it is not a spare but it is part of the RAID?
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!