Lose eth0 setting after reboot

  • Hi guys.
    After rebooting OMV 3.0.32 today, it lost every internet configuration!
    after setting the IP I forgot to set up the gateway, so I made a new profile into "network" tab, but it seemed to have no effect.
    Internet returned to work only after I setted the GW with putty :/
    Can someone help me to understand the reason?

    Intel G4400 - Asrock H170M Pro4S - 8GB ram - Be Quiet Pure Power 11 400 CM - Nanoxia Deep Silence 4 - 6TB Seagate Ironwolf - RAIDZ1 3x10TB WD - OMV 5 - Proxmox Kernel

  • sorry, maybe I wasn't explaining well, the problem is not the GW
    Is that after the restart I lose the eth0 settings AND the settings of the webgui doesn't work

    Intel G4400 - Asrock H170M Pro4S - 8GB ram - Be Quiet Pure Power 11 400 CM - Nanoxia Deep Silence 4 - 6TB Seagate Ironwolf - RAIDZ1 3x10TB WD - OMV 5 - Proxmox Kernel

  • # The loopback network interface
    auto lo
    iface lo inet loopback



    # eth0 network interface
    auto eth0
    allow-hotplug eth0
    iface eth0 inet static
    address 192.168.1.5
    gateway 192.168.1.1
    netmask 255.255.255.0
    dns-nameservers 8.8.8.8 8.8.4.4
    pre-down ethtool -s $IFACE wol g
    iface eth0 inet6 manual
    pre-down ip -6 addr flush dev $IFACE

    Intel G4400 - Asrock H170M Pro4S - 8GB ram - Be Quiet Pure Power 11 400 CM - Nanoxia Deep Silence 4 - 6TB Seagate Ironwolf - RAIDZ1 3x10TB WD - OMV 5 - Proxmox Kernel

  • mmm, I reboot again today and now is fine :/ not really sure about what happen. I lost my config 2 times :(

    Intel G4400 - Asrock H170M Pro4S - 8GB ram - Be Quiet Pure Power 11 400 CM - Nanoxia Deep Silence 4 - 6TB Seagate Ironwolf - RAIDZ1 3x10TB WD - OMV 5 - Proxmox Kernel

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!