Hi guys.
After rebooting OMV 3.0.32 today, it lost every internet configuration!
after setting the IP I forgot to set up the gateway, so I made a new profile into "network" tab, but it seemed to have no effect.
Internet returned to work only after I setted the GW with putty
Can someone help me to understand the reason?
Lose eth0 setting after reboot
-
- gelöst
- OMV 3.x
- Blabla
-
-
Unless you have a complex setup and you're accesing the server from another ip subnet different from Omv then the gateway matters, in a simple environment just assigning the IP address should give you access to the server from other Lan clients connected to the network bridge.
-
sorry, maybe I wasn't explaining well, the problem is not the GW
Is that after the restart I lose the eth0 settings AND the settings of the webgui doesn't work -
Post here the relevant file
/etc/network/interfaces
-
# The loopback network interface
auto lo
iface lo inet loopback# eth0 network interface
auto eth0
allow-hotplug eth0
iface eth0 inet static
address 192.168.1.5
gateway 192.168.1.1
netmask 255.255.255.0
dns-nameservers 8.8.8.8 8.8.4.4
pre-down ethtool -s $IFACE wol g
iface eth0 inet6 manual
pre-down ip -6 addr flush dev $IFACE -
Well are those settings the configured ones ? you said these are different from the ones in the UI?
-
mmm, I reboot again today and now is fine not really sure about what happen. I lost my config 2 times
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!