Hi.
I'm trying to set up my solution with wireless network to a D-link wireless router with a Buffalo wli-uc-g300n (ralink rt2870 chip). I've downloaded and installed firmware-ralink driver.
I've got it on WPA2 PSK. I think with AES "password".
Read a lot of help sites but I can't find a real setup files anywhere.
This is my setup as for now: What is correct? And what do I need to do?
Here's my interfaces file (commented out things to test. Please let me know what I need and don't need.
Code
# The loopback network interface
auto lo
iface lo inet loopback
# eth0 network interface
auto eth0
allow-hotplug eth0
iface eth0 inet static
address 192.168.137.10
gateway 192.168.137.1
netmask 255.255.255.0
dns-nameservers 192.168.137.1
# wlan0 network interface
auto wlan0
iface wlan0 inet dhcp
# address 192.168.0.10
# gateway 192.168.0.1
# netmask 255.255.255.0
# dns-nameservers 192.168.137.1
# wpa-ssid "SSIDname"
# wpa-psk "passphrase"
# wpa-key-mgmt WPA-PSK
# wpa-group TKIP CCMP
#wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
Alles anzeigen
Here's my wpa_supplicant.conf