Move Boot from USB Flash Stick to SATA or to another USB Device

    • OMV 4.x

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • ajaja wrote:

      Is there a procedure to move the Boot volume to another device?
      Boot from clonezilla
      Clone usb stick to other drive.
      remove original usb stick
      set bios to boot from new device
      omv 4.1.22 arrakis | 64 bit | 4.15 proxmox kernel | omvextrasorg 4.1.15 plugins source code and issue tracker - github

      Please read this before posting a question and this and this for docker questions.
      Please don't PM for support... Too many PMs!
    • oh id didnt know that, i used e separate pc and it did work.

      but after booting the the new ssd with the old data, the eth1 and eth2 did switch to eno1 and eno2.
      so i could not see the no network was visible.
      with attaches monitor and Konsole ifconfig i could see this.

      ifconfig eno1 netmask
      i changed the data from something to the correct ip and netmask, so i could open the OMV with browser.

      in OMV Network i deleted the old eth1 and searched for a new one which is the eno1, reboot, and everything is fine.

      after this i enlarged the boot and swap partition with GParted on external linux.
      first deleting everything but boot, than enlarging boot and new(larger) swap partition.
      after the first boot, i received some zombies, but now everything is fine 2.0.
      boring OMV.
      it runs and and runs and runs and runs and ru ...

      The post was edited 1 time, last by rsrsrs: gparted ().