Move Boot from USB Flash Stick to SATA or to another USB Device

    • Offizieller Beitrag

    Is there a procedure to move the Boot volume to another device?

    Boot from clonezilla
    Clone usb stick to other drive.
    remove original usb stick
    set bios to boot from new device
    done.

    omv 7.0.4-2 sandworm | 64 bit | 6.5 proxmox kernel

    plugins :: omvextrasorg 7.0 | kvm 7.0.10 | compose 7.1.2 | k8s 7.0-6 | cputemp 7.0 | mergerfs 7.0.3


    omv-extras.org plugins source code and issue tracker - github


    Please try ctrl-shift-R and read this before posting a question.

    Please put your OMV system details in your signature.
    Please don't PM for support... Too many PMs!

  • it is possible to do this on a separate Pc?


    old boot usb stick
    and
    [USB adapterkabel SSD] in a laptop,
    booting clonezilla, copy data,
    than
    [USB adapterkabel SSD] in the HP ProLiant MicroServer Gen8


    and done?

    boring OMV.
    it runs and and runs and runs and runs and ru ...

    • Offizieller Beitrag

    it is possible to do this on a separate Pc?

    Yes

    omv 7.0.4-2 sandworm | 64 bit | 6.5 proxmox kernel

    plugins :: omvextrasorg 7.0 | kvm 7.0.10 | compose 7.1.2 | k8s 7.0-6 | cputemp 7.0 | mergerfs 7.0.3


    omv-extras.org plugins source code and issue tracker - github


    Please try ctrl-shift-R and read this before posting a question.

    Please put your OMV system details in your signature.
    Please don't PM for support... Too many PMs!

  • oh id didnt know that, i used e separate pc and it did work.


    but after booting the the new ssd with the old data, the eth1 and eth2 did switch to eno1 and eno2.
    so i could not see the no network was visible.
    with attaches monitor and Konsole ifconfig i could see this.


    with:
    ifconfig eno1 192.168.100.1 netmask 255.255.255.240
    i changed the data from something to the correct ip and netmask, so i could open the OMV with browser.


    in OMV Network i deleted the old eth1 and searched for a new one which is the eno1, reboot, and everything is fine.


    after this i enlarged the boot and swap partition with GParted on external linux.
    first deleting everything but boot, than enlarging boot and new(larger) swap partition.
    after the first boot, i received some zombies, but now everything is fine 2.0.

    boring OMV.
    it runs and and runs and runs and runs and ru ...

    Einmal editiert, zuletzt von rsrsrs () aus folgendem Grund: gparted

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!