omv-firstaid do not configure network on exit
-
-
what can be the problem?
Just reboot, had the same error when I changed machines.
-
error is the same if I reboot and try omv-firstaid next time.
error is the same for DHCP & for manual config.
I'm desesperate.
I do not understand why do not work and configure NIC
HOW to configure NIC by hand eg: assing IP by DHCP?
-
-
error is the same if I reboot and try omv-firstaid next time.
There's no need to run firstaid again, all I did was move all the drives to another machine without connecting them, booted from usb flash drive ran firstaid and applied a fixed ip, rebooted then just logged into the GUI, to make sure I could, shutdown, connected drives and restarted. No idea why the error appeared but having run firstaid twice and got the same error, the third time I ignored it it.
-
to understand:
you say that omv need data disk to run properly firstaid?
-
you say that omv need data disk to run properly firstaid?
No, sorry sometimes my explanation is not very good.
Run firstaid (I found it easier to use a fixed ip) when the configuration is finished you'll get the error ignore it and reboot, then test by using the ip in your browser as you would normally, you should get the login screen.
-
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!