Network card reduce after standy by to 10mbit

    • OMV 4.x
    • Network card reduce after standy by to 10mbit

      Hey all,

      has someone the same issue with the network card from the NAS , after start out of the standy by it is reduce to 10mbit. ?(
      if I reboot my Nas then I have 100mbit
      I have this problem since kernel 4.18

      thats shows ethtool eth0

      Source Code

      1. /etc$ ethtool eth0
      2. Settings for eth0:
      3. Supported ports: [ TP AUI BNC MII FIBRE ]
      4. Supported link modes: 10baseT/Half 10baseT/Full
      5. 100baseT/Half 100baseT/Full
      6. 1000baseT/Full
      7. Supported pause frame use: Symmetric Receive-only
      8. Supports auto-negotiation: Yes
      9. Advertised link modes: 10baseT/Half 10baseT/Full
      10. 100baseT/Half 100baseT/Full
      11. 1000baseT/Full
      12. Advertised pause frame use: Symmetric Receive-only
      13. Advertised auto-negotiation: Yes
      14. Link partner advertised link modes: 10baseT/Half 10baseT/Full
      15. 100baseT/Half 100baseT/Full
      16. Link partner advertised pause frame use: No
      17. Link partner advertised auto-negotiation: Yes
      18. Speed: 100Mb/s
      19. Duplex: Full
      20. Port: MII
      21. PHYAD: 0
      22. Transceiver: internal
      23. Auto-negotiation: on
      24. Supports Wake-on: pumbg
      25. Wake-on: g
      26. Current message level: 0x00000033 (51)
      27. drv probe ifdown ifup
      28. Link detected: yes
      Display All

      I use

      Release: 4.1.22-1
      Codename: Arrakis
      4.19.0-0.bpo.4-amd64 #1 SMP Debian 4.19.28-2~bpo9+1 (2019-03-27) x86_64 GNU/Linux