Rockpro64 hard drives are not seen by omv until reboot

    • Rockpro64 hard drives are not seen by omv until reboot

      [/quote]I read the posts and I saw that arm64 uses 663Mb Vs 363 Mb armhf but I think nobody identified if performance is better in arm64 or armhf, I could have missed something.
      My board has 4 GB and I started configuring arm64, is it worth going back to armhf in my case?
      I will try to run quiet a few dockers, tvheadened, jackett, radarr, sonarr, deluge, some type of Kodi, letsencrypt, airsonic, possibly nextcloud.[/quote]




      The gain in using arm vs armhf is about 15 ~ 20% in speed I believe.

      Sent from my PH-1 using Tapatalk
    • vecnar wrote:

      I read the posts and I saw that arm64 uses 663Mb Vs 363 Mb armhf but I think nobody identified if performance is better in arm64 or armhf
      Check the links in the link. I tested and found no relevant performance differences. But this was a special use case (NodeJS) and maybe 'worst case' as well. With 4GB simply don't think about the architecture any more.
      No more contributions to this project until 'alternative facts' (AKA ignorance/stupidity) are gone
    • Users Online 1

      1 Guest