I went ahead an booted my omv and this is what I see now. It's not showing anything like it's brand new. I haven't done any changes and I usually keep this turned off.
OMV now reverts to default and nothing else shows when booted.
-
- OMV 3.x
- gelöst
- Jaime
-
-
Default in is admin/openmediavault
Do not log in to the webUI as root/root password or as a user you created.
-
Yeah, but I need my stuff back not a default.
-
-
Again... LOG IN AS ADMIN, not as a user (that's what it looks like your'e doing)
-
If you forgot your admin password, you can ssh to your server (or use local access) and then use omv-firstaid to reset the password of the GUI
-
Thanks guys. No I haven't forgotten any of my passwords. I just haven't been using the system much so I tend to forgot some of this stuff. System has just been acting up since it couldn't get any more updates on it. In any case, I decided to change the hard drive since I was using an extra adapter on an old ide drive and installed a slightly bigger drive that no longer uses that sata to ide adapter. I went ahead and installed the new omv 4 and although it took a little while I think I'm back up. One note when updating from one version to the next, I mean new install not updating. Make sure to either write down all your shares or get a screenshot because you will need that to get those shares going again. I couldn't remember a couple of them but found my screenshot so they're all back again. Phew. I just need to configure everything else back.
-
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!