Hello,
My OMV V2 server OS drive died over the weekend, so I have now installed OMV V4. My old OMV server had 2 RAID drives, a RAID 1 disk and a RAID 5 disk. Both drives were working fine and the S.M.A.R.T. status was green.
Once the install was completed, both RAID volumes are shown in the RAID Management section (/dev/md126 & /dev/md127). When I go to the File System section, OMV has only picked up the RAID 5 volume(/dev/md126, which I successfully mounted) but does not list the RAID 1 volume (/dev/md127).
If I run cat /proc/mdstat I get the following:
Personalities : [raid1] [raid6] [raid5] [raid4] [linear] [multipath] [raid0] [raid10]
md126 : active raid5 sde[1] sdf[2] sdd[0]
1953262592 blocks super 1.2 level 5, 512k chunk, algorithm 2 [3/3] [UUU]
md127 : active (auto-read-only) raid1 sdc[2] sdb[3]
1953383360 blocks super 1.2 [2/2] [UU]
unused devices: <none>
Any tips on how I can get the system to see the RAID 1 volume in the File Systems section?