Hello,
OMV 4 is running on a HP microserver gen8 since a long time without any problems.. Since this month I had a lot of trouble with this combination.
I tried setting up a new OMV 4 on a new SSD and tried using the old HDD OMV system.
Both versions are showing the same message at every booting of the system for minutes:
„A start job is running for Raise network interfaces“
Before this, I was using NIC1 (eno1). But OMV was not able to find any ethernet interface. So I switched to eno2 using omv-firstaid. On eno2 the WebGui and network is coming up, but it takes a long time.
Are there any solutions?