OMV4 with SATA PCI-e adapter doesn't boot

    • OMV 4.x

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • OMV4 with SATA PCI-e adapter doesn't boot


      I make a new OMV 4.19 NAS on a optiplex 390. My nas works very well with only 2 SATA harddrives: one SSD with the OMV system and other one with datas.
      Now, I want to add a new SATA datas harddrive but my motherboard has only 2 SATA slots.

      So, I bought 2 differents SATA adapter (PCI-E X1) with the same effect: As I physicaly attached a SATA drive on the card adapter and reboot the NAS, my NAS doesn't want boot anymore (GRUB doesn't launch).
      I precise, if I attach the SATA drive AFTER the boot, there is no problem! I can see and mount the drive from the Web GUI or SSH.

      My Sata adapters are:
      - Marvel 88SE9125 rev1.1 (Hightpoint Rocket 620)
      - ASMEDIA ASM1061

      I performed this installation:


      1. echo "deb stretch-backports main contrib non-free" >> /etc/apt/sources.list
      2. apt-get update
      3. apt-cache search linux-image-4
      4. apt-get -t stretch-backports install linux-image-4.19.0-0.bpo.5-amd64 firmware-linux-free

      Do you know why my NAS doesn't want to boot with a disk physically attached to my SATA adapter?
      I think there is probably a way to boot by changing "/etc/fstab" but I don't know how to proceed...

      Source Code

      1. UUID=c3e88598-d1f6-4e96-bbb2-2b6464bad04d / ext4 errors=remount-ro 0 1
      2. # swap was on /dev/sda5 during installation
      3. UUID=1f701467-a02d-4128-837a-a859b0c01449 none swap sw 0 0
      4. /dev/sr0 /media/cdrom0 udf,iso9660 user,noauto 0 0
      5. tmpfs /tmp tmpfs defaults 0 0
      6. # >>> [openmediavault]
      7. /dev/disk/by-label/Seagate4To /srv/dev-disk-by-label-Seagate4To ext4 defaults,nofail,user_xattr,noexec,usrjquota=aquota.user,,jqfmt=vfsv0,acl 0 2
      8. # <<< [openmediavault]

      Thanks for any help :)

      The post was edited 1 time, last by ramanvda ().