Docker and Conatiner and Volumes is not work here

First off use Bind not Volume, you are going to 'bind' a folder from OMV to a folder in the container.

Zitat von ramus

What do mean, when i going to bind, i See Not My Folders when i give /sharefolders/Archiv Not seee under bind,

You won't see anything there is nothing to select, there are no drop down options, the folder information has to be typed in.

In your picture there are two buttons Volume and Bind click/select Bind

Which plex docker as you using at least I could either download it or have a look at the settings.

Ok we're losing this in the translation so going back to this;

Zitat von ramus

What do mean, when i going to bind, i See Not My Folders when i give /sharefolders/Archiv Not seee under bind,

the above is correct that is because you have to enter them manually, example;
container -> /downloads
host -> /sharefolders/downloads

the above image shows the options when using bind under the Volumes tab, so the host is the share on OMV, the container is where it will find those files.

Zitat von ramus

When i give under Container (who my Settings is from my plex) /sharefolders/plex....

No, the container folder is what is stated on the containers settings, so container is inside the container, host is outside.

What are you using as your image.

Zitat von ramus

my questions is what for Name have Container, this Not Unterstand,

That is why asked what image are you using, if you look at the image I posted the container will have a folder structure, so if Plex has a folder structure of just media, you can therefore use a structure that I posted in my image.

So if Plex just has a folder /media which will be stated in the on the images Docker page, you can then set up the structure as per my picture why, because the host /sharedfolders/movies points to /media/movies and therefore once the Plex GUI is running by selecting the media folder the other folders will be displayed inside it.

This is the only way I can explain it.

@ramus du solltest in Docker keine Pfade mit "/sharedfolder/xxxx" benutzen. Es ist besser den kompletten Pfad zu nehmen: "/srv/dev-disk-by-label-xxxxx/xxxx"

Cannot create shared folder on new or existing drive

Um den Pfad richtig hinzubekommen, benutze ich Putty. Darin navigiere ich zu dem Ordner und kopiere dann den Pfad. Vermeidet einige Tippfehler