I run OMV on a single-disk NAS box. After updating OMV to 4.1.27-1, the hard drive disappeared from the list of physical devices in Storage > Disks (screen shot attached). The disk always populated correctly in the previous OMV build I was using (4.1.23). The original setup was probably customized, so the update reverted some change to defaults.
Attempted: reboting; using the Scan button. I tried attaching an external device to the USB port, and that one shows up under the list of available devices correctly as /dev/sdb
Is there anything I can do to make the built-in hard drive show up again under Storage > Disks? Could it be that OMV does not like the name /dev/sataa instead of /dev/sda ? (this is not going to change, so I need to make OMV accept this path somehow).
omv-rpc -u admin 'DiskMgmt' 'enumerateDevices'
output:
[]
fdisk-l output (trimmed):
Disk /dev/sataa: 7.3 TiB, 8001563222016 bytes, 15628053168 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: gpt
Disk identifier: 9D4BAF77-4266-3DB4-36FB-5053740139E2
Device Start End Sectors Size Type
/dev/sataa1 34 2047 2014 1007K Microsoft basic data
/dev/sataa2 2048 67583 65536 32M Microsoft basic data
lsblk -f output:
NAME FSTYPE LABEL UUID MOUNTPOINT
sataa
├─sataa1
├─sataa2
├─sataa3
├─sataa4
├─sataa5
├─sataa6
├─sataa7
├─sataa8
├─sataa9
├─sataa10
├─sataa11
├─sataa12
├─sataa13
├─sataa14
├─sataa15
├─sataa16
├─sataa17
├─sataa18
├─sataa19
├─sataa20 /
├─sataa21 /var
├─sataa22 /usr
├─sataa23 [SWAP]
└─sataa24 /srv/dev-sataa24