Hello, first post. Glad to be here and thankful for the OMV community.
I've just installed OMV 5 and I'm looking to install drivers for my 10G nic card. I should preface that my Linux experience is a step above newbie, but not quite power user. I've done ./configure make make installs on Linux before.
During the setup, I noticed my 10g nic was not recognized, so I am using the motherboard onboard nic without issue in the meantime. I hopped on the command line right after completing the install, following Techno Dad Life's video guide for OMV complete install plus Portainer. Haven't done much else with my setup.
Downloaded nic drivers from https://www.trendnet.com/suppo….asp?prod=310_TEG-10GECTX
Filename: Driver(Linux)_TEG-10GECTX_v1(0.3.6.17).tar.gz
SHA-1 Checksum: 5E68E8D86C1F94964B34E009E9A8D33521161375
Extracted to a directory in tmp, read the readme, noticed there is no ./configure and make fails with "Makefile:139: *** Aborting the build: Linux kernel /lib/modules/5.4.0-0.bpo.2-amd64/build source not found. Stop.". So here I am, reaching out to the gurus. Help!
Thank you,