I installed OMV v 5.3.2-1 on raspi 4 and attached a segate backup plus 4tb hdd..
I configured SMB as per troubleshooting guide an added these extra parameters.
Complete list of Extra Options are as below:
min receivefile size = 16384
write cache size = 524288
getwd cache = yes
socket options = TCP_NODELAY IPTOS_LOWDELAY SO_RCVBUF=65536 SO_SNDBUF=65536
log level = 1
read raw = yes
write raw = yes
max xmit = 65535
dead time = 15
Even after this my network speed while copying is not going beyond 100-150 Mbps.
I am using Robomirror 2.0 for syncing folders between NAS (Raspi) and my PC.
I also increased threads to 32 to increase performance but its still same.
While i copy file directly.. I can see the performance is better.. but its not upto full. Speed keeps on hovering between 20 MBps to 55 MBps (160 mbps to 500mbps apprx).
Still this is not utilizing my 1GBps connection to full.
On PC, the NIC is set to Auto-negotiate and Raspi it show 1Gbps.
Below is the config details for eth0.
Not sure what is the issue and why I am not getting full speed. Router is the Bell Router which was provided and both are connected using Cat 5E/6 cables.
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: gs
Wake-on: d
SecureOn password: 00:00:00:00:00:00
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
--------------------------------------------------------------------------------
Driver information eth0:
========================
driver: bcmgenet
version: v2.0
firmware-version:
expansion-rom-version:
bus-info:
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no