Test NAS doesn't boot after update to latest Beta Version

lefelix · 28. August 2014

Hello,

today I updated my testing NAS to the latest OMV 1.0 beta (beside ownCloud the only update available today), after that I restarted the Machine (replacing a drive).
At some point the boot process stops, after getting an ipv4 address and loading the smb stuff.
Here is a Link to a video from the boot process.

http://brushzone.de/boot_nas.mov

I cannot do anything from the console nor access it via telnet/ssh, a ping is possible.
Any ideas what went wrong or how to fix it?

best

tekkb · 28. August 2014

Did you connect a keyboard, mouse and monitor to see what it shows? You have to do this if you cannot connect via ssh.

lefelix · 28. August 2014

Yes, I have to. The connecting via network have just been for testing.
And for Info, the other Consoles are empty.

lefelix · 5. September 2014

Can be closed, as I did not found the failure I just reinstalled the System

KM0201 · 6. September 2014

Hmm, well nevermind. Just saw the video. I figured it was probably just doing a quota check.

toppi · 6. September 2014

Had the same some days ago when I installed OMV by a friend of mine.

I´ve finished the setup configured some plugins and thought "might be good to reboot" and OMV was not available. After some time we went downstairs and saw a quota check. We left OMV allone and after about 1h he finished and workes again. I then disabled quota checks

Jetzt mitmachen!