New issue network config mixed up after NIC swap New issue

Hi

i just installed OMV
after finishing the install i had to swap a nic to a different slot
I managered to get the nics back in the right order in the system

but on the RRD graphs the interfaces are still in the wrong order

how do I get the order corrected ?

The RRD crown job corrected this automaticly...
Everything is fine now

I discovered a new issue

one port on my Intel X520 DA2 frequently does stop working

dmesg

[81250.393754] ixgbe: eth3 NIC Link is Down
[81251.831435] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None
[81255.685731] ixgbe: eth3 NIC Link is Down
[81257.822266] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None
[81277.028958] ixgbe: eth3 NIC Link is Down
[81279.788440] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None
[81535.613828] ixgbe: eth3 NIC Link is Down
[81537.391954] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None
[81538.979849] ixgbe: eth3 NIC Link is Down
[81539.388901] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None
[81554.005443] ixgbe: eth3 NIC Link is Down
[81555.364299] ixgbe: eth3 NIC Link is Up 10 Gbps, Flow Control: None

ifdown eth3 and ifup eth3 solves the problem

Are there any issue installing the latest backport kernel on OMV to have newer NIC drivers ....

current one are a little old

root@nfsstorage2:~# modinfo e1000e | grep version
version: 1.2.20-k2
srcversion: AB58ACECA1618E521F58503
vermagic: 2.6.32-5-amd64 SMP mod_unload modversions