good evening, i am currently stuck.... and could do with a little assistance....
i have purchased the quad sata hat kit from ALLNET and received it, set it up so it detects the hard drives, and installed OMV5 on my RPI4 4GB.... when typing in LSBLK it registers all the hard drives i have installed, 2x500gb, 1x250gb and 1x120gb sda sdb sdd sdc
Also purchased a laptop 65w USB c power brick so I know the power isn't a problem.
when i go to config omv5 in the disks section i am unable to see all the hard drives, only 2 sdc & sdd
is there anything i do or code to apply to gain access to all of the drives in omv so i can configure and start to use?