Problem Setting Up Link Aggregation

Hi,

I'm pretty new in using OMV. My NAS has two LAN ports (Supermicro X11SSH-F) and my router is an Asus AC66U (Asuswrt-Merlin firmware) all of which is capable of implementing Link Aggregation. So I decided to take advantage of it.

For my router, I followed Method 1 of the guide in GitHub. I think I have setup it up properly because when I run the script LinkAgg -s I get "Bond Status: bond0 UP". On the webGUI of my router, I can also see that two of my ports has the same IP address pointing to my OMV.

I also think that I was able to setup Link Aggregation in OMV properly because I think it was pretty simple. On the options for bonding I chose 802.3ad which is the only only mode also being supported by my router.

However, checking on the System Logs, I found the following lines:

Jul 16 06:04:56 TheVault kernel: [  361.801517] bonding: bond0: An illegal loopback occurred on adapter (eth1).
Jul 16 06:04:56 TheVault kernel: [  361.801522] Check the configuration to verify that all adapters are connected to 802.3ad compliant switch ports
Jul 16 06:04:57 TheVault kernel: [  363.001436] bonding: bond0: An illegal loopback occurred on adapter (eth0).
Jul 16 06:04:57 TheVault kernel: [  363.001440] Check the configuration to verify that all adapters are connected to 802.3ad compliant switch ports

Please, help me figuring out the problem. Thanks.

Hi all,

I resolved this issue already. Problem is not with OMV but with my Asus router. I disabled NAT Acceleration in the router and everything worked fine. Thanks.