I am using openmediavault on my NanoPI M4 board and it works like a charm. I recommend it. Besides, I do have some problem...
The network setup has two static IP addresses where one belongs to VLAN interface. Everything works nice until power loss happens and returns again when I experience changes on the network interface which are not actually possible to find in settings (network config is as it should be). Settings are unchanged but it all acts like it was configured to accept DHCP and it obtains DHCP address until I reboot it and everything is back to normal with two addresses and VLAN settings. The same thing will happen if I disconnect the LAN cable from it and return again. The system immediately loses the configured addresses and obtains DHCP. Restarting network doesn't help. Only reboot of the system helps.
Anyone knows what could possibly cause this behavior?