Hi all,
So setting up ZFS but noticed that most/all attributes arent set or are and just wondering if they are right?
Eg Compression=off
I set it to =lz4
Just wondering if there is anything else that should be set for a good new ZFS install?
Hi all,
So setting up ZFS but noticed that most/all attributes arent set or are and just wondering if they are right?
Eg Compression=off
I set it to =lz4
Just wondering if there is anything else that should be set for a good new ZFS install?
atime=off
aclinherit=passthrough
xattr=sa
sync=standart
acltype=posixacl
compression=lz4
and also ashift=12 on creation zfs
Nice thanks, can you explain all of that?
Also did you get this from Proxmox or somewhere?
Nice thanks, can you explain all of that?
See here: Introducing ZFS Properties
sync=standart
sync=standard
Some users are using only this properties:
aclinherit=passthrough
acltype=posixacl
xattr=sa
set compression=lz4
and also ashift=12 on creation zfs
ashift=12 creates the correct alignment for 4k sector disks.
ashift=12 creates the correct alignment for 4k sector disks.
Thats pretty much most/all modern drives right. I am using WD Red 8tb's.
So this would be a good setting to use right?
So far:
ashift=12
aclinherit=passthrough
acltype=posixacl
xattr=sa
set compression=lz4
atime=off
Is this a good/best setup for a new ZFS pool?
Thats pretty much most/all modern drives right. I am using WD Red 8tb's.
Yes.
@savellm Also have a look at this post: [HOWTO] Instal ZFS-Plugin & use ZFS on OMV
Cheers will do
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!