I know I can count on you on this one.
Here is the deal : I did not notice that from the begininng after I moved in my new house, but since then, my network card is set up to 100Mb/s instead of 1Gb/s.
Again with my switch (Netgear GS116Ev2 - 16-Port Gigabit Ethernet Smart Managed Plus Switch) :
I don't understand why because all the other hardwares are connected with 1000Mb/s autoneg full duplex.
If I try to force autoneg off and speed 1000 on card with :
I don't get the network starting.
I tried switching the cables on same port on the switch, and between PC and NAS and same...
Everything I plug on the switch, whatever the port, it is autoneg 1000Mb/s OK, so the problem definitely comes from OMV...
Backports are enabled :
More information :
- Hardware on signature
- apt-get update && install done
- eth0 = embedded network card (never been used)
- eth1 = intel PCIe card
- I reinstall these drivers https://downloadcenter.intel.c…sous-Linux-?product=32209 with no luck
Also for your information :
Thanks for you all.