Hi,
I was using OMV 2 for some years with SnapRaid.
For the upgrade to OMV 5 I decided to install OMV 5 fresh, instead of upgrade step by step.
I have a HP microserver Gen8 G1610T with 4 disk with SnapRAID + SD in the ODD port for OMV and a USB boot stick in the internal USB slot
As this is a tricky environment, I had to follow these steps:
1. disconnect the SnapRaid disk + the internal USB boot stick
2- install OMV 5 on the SD on the ODD port
-->test successful - OMV was coming up
3. activate the boot stick in the internal USB slot
-->connecting the 4 disk again and boot the system
Now OMV 5 is up and running on the SD (ODD port)
In the disk settings I can see the 4 disks with the same device name as it was under OMV 2
Installing SnapRaid and aufs (Union FS)
Based on my preparation, I thought I have to setup the SnapRaid in the same way again and all will working as it was before. But although I could see the 4disks from the SnapRaid in the disk section, I could not choose the disk in the snapRaid configuration
(note: also in other views like Raid configuration, I could not select any of these disks)
If I mount the disk manually, I can still see all the data on the disk
Any idea how I will be able to configure the disks in the SnapRAID?
Thanks & Regards,
ichfunktion